The Polished Crystal Necklace pattern is looping lace worked in bead weaving. In the top sample I used 6mm doughnut beads, but you can also use Fire-polished 4mm crystals. It is not hard to make even though it might look like a lot of work.
A = 11/0 seed bead
B = 4mm crystal
Start by waxing and stretching your thread, use Nymo D or C-Lon & a #11 or #12 beading needle. Tie in a "stopper" bead, leaving about an 8" tail and begin at step #1.
10. Pick up 7A, go with thread up through the 7th A bead added in step #9.
11. Pick up 7A, make a circle and go with thread down through the 5th & 6th A beads added in step #9, and up through the 1st & 2nd A beads just added in this step.
![]() |
12. Continue necklace by repeating steps #3 though #11 until you reach the length that you want, then finish at the next step |

13. To add clasp, Pick up 3A, clasp, 3A, go with thread up through 2 beads in necklace, continue with thread around through the clasp and necklace beads a couple of times, then weave in and end your thread. Repeat clasp directions in the same manner on the other end, after removing the stopper bead.
Sandra D. Halpenny © 2007 - 2018 All rights reserved, This pattern may not be copied in any way without the express written
permission of the author.
Click here for more patterns
Christmas Tree Garland Necklace Pattern
Easy Christmas Necklace Pattern
Snowflake #3 Necklace Pattern
Click here for more patterns
No comments:
Post a Comment